Building Energy Resilience

In Vermont’s commercial construction industry, the word is well out there by now that the 2020 Commercial Building Energy Standards mandate building air barriers receive special attention, to some degree – either at post-envelope construction by way of a blower door test, or throughout the construction phase by way of commissioning (no blower door test). I’ve discussed portions of this in the past when it was relatively new. The 2021 IECC release now also mandates either air barrier commissioning or blower door testing. It will be some time before states begin to adopt this version of the code, but it is only a matter of time. So, I thought it a good idea to get out ahead and discuss why I think we, as an industry, should be considering the two of these options in harmony, rather than separately.

In my first blog on Common VRF (Variable Refrigerant Flow) Installation Issues I focused on issues during mechanical and hardware installation that typically lead problems during startup and pre-functional checkout commissioning. This blog will focus on controls issues identified during commissioning design review which usually lead to issues during start up if not addressed up front during design. As mentioned in the previous article, VRF systems can allow for better comfort and overall satisfaction, but if not properly programmed for the owner’s specific application, can lead to numerous complaints during the first year of occupancy.

Photo by Adam Rouse

A few years ago, while living in a small apartment in Montreal’s Plateau neighborhood, I noticed that the lightbulb in my kitchen had burned out. Naturally, I went to the hardware store to find a replacement. After struggling to read the French labeling on several different packages, I ultimately decided to go for the least expensive box of LED bulbs that the store had available. Once I installed the newly purchased lightbulb, I noticed a difference in the way our kitchen looked. Specifically, I noticed a difference in the appearance of the bowl of fruit that always sat on the counter. While the lightbulb illuminated the space, I remember thinking to myself how unappetizing and dull my fruit now looked. This exercise, though unintentional, clarified the importance of a light source’s color rendering capability.

Thanks for following the second part of the ground coupled heat pump design. If you haven’t already, now’s a good time to go back and read Part 1. In the first part of this post, we discussed the importance of understanding thermal imbalance in a ground source heat pump system and the longevity impacts associated with an imbalanced system. Despite the issues associated with a thermally imbalanced system, there are ways to address building loads with additional technology that will further enhance the performance of the ground-coupled heat pump system, as well as provide long term performance.

I looked back through our blog history and realized I have never written about the importance of a lovely little document called the Owner’s Project Requirements, or OPR for short.  An OPR is created through collaboration with many involved parties; it synergizes everyone’s ideas into one goal-focused document. At Cx Associates we are such believers in defining the goals and criteria for project success that we often develop OPRs even for internal business improvements to help focus and guide the process.  

We often hear a question that goes something like this from building owners: “Why do I need an independent design review? I hire the best architects and engineers.” It’s a reasonable question — asked so often in my opinion because those of us in the architecture, engineering and construction industries have done such a poor job answering.